Rohde & Schwarz R&S SMW200A - Page 1290

RF Hardware Versions
R&S
®
SMW200A
1290User Manual 1175.6632.02 ─ 30
Synthesizer RF frequency options Reference frequency Phase noise perfor-
mance options
Analog modulation
options
SSYNW
1412.6567.02
R&S SMW
●
-B1003/-B1006/...
(path A)
●
-B2003/...(path B)
R&S SMW
●
-K703 (1 GHz refer-
ence)
●
-K703 (100 MHz ref-
erence, low noise)
-K704 (1 MHz to 100
MHz variable refer-
ence)
R&S SMW
●
-B709/-B710/... (path
A)
●
-B719/-B720/... (path
B)
●
R&S SMW-K720
AM/FM/PhiM
(not available for
R&S SMW-B2031/-
B2044(N))
SSYN
1412.6667.02
R&S SMW-
●
-B103/-B106/... (path
A)
●
-B203/... (path A)
--- R&S SMW-B22 enhanced
phase noise & FM/PhiM
modulator
R&S SMW
●
-B20 FM/PhiM modu-
lator
●
R&S SMW-B22
enhanced phase
noise & FM/PhiM
modulator
SSYN
1141.4220.02
See the data sheet for information on all RF frequency and RF enhancement options,
the provided path combinations and the corresponding RF characteristics.
A.2 Affected Parameters and Settings
The following table shows the impact of the new RF hardware components on the set-
ting parameters, denoted by the synthesizer versions.
For more information, see data sheet.
Table A-1: Reference oscillator settings
Synthesizer External RF reference fre-
quency
Minimum frequency locking range Reference frequency output
SSYNW
1412.6567.02
●
10 MHz, 100 MHz, 1 GHz
●
100 MHz low noise
●
1 MHz to 100 MHz
●
Variable
Depends on the synchronization
bandwidth setting (narrow/wide) and
the installed phase noise options
R&S SMW-B709/-B710/-B711.
●
10 MHz, 100 MHz, 1 GHz
●
100 MHz low noise
●
Input signal (loop through)
SSYN
1412.6667.02
●
10 MHz
●
1 MHz to 100 MHz variable
Depends on the synchronization
bandwidth setting (narrow / wide)
and the installed phase noise option
R&S SMW-B22.
●
Same as reference input
●
10 MHz derived from Ref.
output
SSYN
1141.4220.02
5 MHz, 10 MHz or 13 MHz
Affected Parameters and Settings