Elements and Controls of the Graphical User Interface
R&S
®
SMW200A
1298User Manual 1175.6632.02 ─ 30
Trigger State
Indicates the state of the trigger signal in the baseband domain.
The trigger can be in the following states:
Table C-2: Indication of trigger signal activities in the different views
Block diagram Trigger settings dialogs Tab label (settings dialog)
Access to the "Trigger" tab in the "Trigger Marker Clock" dialog.
Touchscreen Off
Indicates that the security function "Touchscreen Off" is set.
This function locks the manual control on the screen. You can operate the instrument
over VNC, and the front panel keys or external keyboard and mouse. The R&S SMW
displays the icon in the upper left corner of the block diagram.
Access to the "Security" dialog.
VNC Only
Indicates that the security function "VNC Only" is set.
This function locks the front panel keys and the external keyboard and mouse. You can
operate the instrument over VNC, or the touchscreen. The R&S SMW displays the icon
in the upper left corner of the block diagram.
Access to the "Security" dialog.
Disabled
Indicates that the security function "Disabled" is set.
This function locks all controls for manual operation of the instrument. You can operate
the instrument via remote control only. The symbol covers the entire screen.
C.3 Elements in the Task Bar
The task bar contains labeled softkeys and minimized views (thumbnails) of active
graphics and dialogs.
In general, you can access all functions that are assigned to a softkey directly. Apart
from "System Config "and "Current Dialogs", the first two firmly assigned softkeys, a
further permanent softkey is displayed, denoting that the instrument is in remote con-
trol mode.
In addition, you can permanently indicate externally connected devices as, e.g., an
R&S NRP-Z power sensor.
Elements in the Task Bar
To Next Page
Loading...