Rohde & Schwarz R&S SMW200A - Page 134

Signal Routing and System Configuration
R&S
®
SMW200A
134User Manual 1175.6632.02 ─ 30
See also:
●
"Fading Simulation" user manual, description of the parameter "Dedicated Fre-
quency".
●
"Combination Mode" on page 134.
Remote command:
:SCONfiguration:OUTPut:MAPPing:STReam<st>:FOFFset on page 921
Phase Offset
Option: R&S SMW-B9 - available if "Signal Outputs = Analog Only"
Sets the phase offset of the corresponding stream.
Remote command:
:SCONfiguration:OUTPut:MAPPing:STReam<st>:POFFset on page 921
Map Stream X to Connector
The mapping of the generated streams to the output connectors is represented as a
stream matrix. A blue circle at a matrix element routes the selected stream to the cor-
responding connector.
To map more than one stream to an output connector, enable the Combination Mode.
The stream mapping to the FADER connectors is fixed.
Remote command:
:SCONfiguration:OUTPut:MAPPing:RF<ch>:STReam<st>:STATe on page 920
:SCONfiguration:OUTPut:MAPPing:IQOutput<ch>:STReam<st>:STATe
on page 920
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:STReam<st>:STATe
on page 920
:SCONfiguration:OUTPut:MAPPing:FADer<ch>:STReam<st>:STATe
on page 920
:SCONfiguration:OUTPut:MAPPing:BBMM<ch>:CHANnel<di>:STReam<st>:
STATe on page 920
Combination Mode
Defines the way the streams are internally processed if multiple streams are routed to
the same physical connector.
Tip: Use the parameter f
offset
, MHz to shift the frequency bands of the streams in the
frequency domain.
"Single"
One stream can be routed to several connectors but only one stream
can be mapped on each connector.
"Add"
If more than one stream are routed to the same RF, I/Q or BBMM
connector, they are added equally weighted.
"Mux"
Option: R&S SMW-K18
Enables stream multiplexing at the digital connectors. The exact
parameters are defined in the "Digital I/Q Output" dialog.
Tip: This mode is useful to output the generated signals of a higher-
order MIMO configuration at less digital connectors. The connected
instrument must support stream multiplexing.
See Chapter 4.7, "I/Q Digital Output Settings", on page 172
System Configuration Settings