Rohde & Schwarz R&S SMW200A - Page 149

Signal Routing and System Configuration
R&S
®
SMW200A
149User Manual 1175.6632.02 ─ 30
Apply and Connect
Confirms the settings and triggers the connection establishment. In the connected
instruments, the status of this active remote connection is displayed by the "Remote"
indication.
Remote command:
:SCONfiguration:EXTernal:CODer<ch>:REMote:ISELect on page 931
:SCONfiguration:EXTernal:CODer<ch>:REMote:CONNect on page 932
:SCONfiguration:EXTernal:FADer<ch>:REMote:ISELect on page 931
:SCONfiguration:EXTernal:FADer<ch>:REMote:CONNect on page 932
:SCONfiguration:EXTernal:BBMM<ch>:REMote:ISELect on page 931
:SCONfiguration:EXTernal:BBMM<ch>:REMote:CONNect on page 932
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:ISELect on page 931
:SCONfiguration:EXTernal:IQOutput<ch>:REMote:CONNect on page 932
:SCONfiguration:EXTernal:RF<ch>:REMote:ISELect on page 931
:SCONfiguration:EXTernal:RF<ch>:REMote:CONNect on page 932
Remote Control Settings
Access:
1. Select "Taskbar > System Config > System Configuration > External RF and I/Q".
2. Navigate to the required connector.
Select "External Instruments > Config ...".
3. In the "<Dig. Conn. Name>: External Instrument Configuration" dialog, select
"Remote Control".
In this dialog, you can send individual SCPI commands or a sequence of SCPI
commands to the connected instruments.
System Configuration Settings