Rohde & Schwarz R&S SMW200A - Chapter 4 Digital Baseband Input Settings

Signal Routing and System Configuration
R&S
®
SMW200A
158User Manual 1175.6632.02 ─ 30
Signal Routing
Requires R&S SMW-B10.
Defines the way the baseband signal (internally generated or externally provided) is
routed in the instrument. When routing more than one signals to the same path, the
signals are summed.
"Route to path A"
The internal or external baseband signal is routed to path A.
"Route to path B"
The internal or external baseband signal is routed to path B.
"Route to path A and B"
The internal or external baseband signal is routed to both paths.
Remote command:
[:SOURce<hw>]:BB:ROUTe on page 987
[:SOURce<hw>]:BBIN:ROUTe on page 987
4.6 Digital Baseband Input Settings
The R&S SMW provides interfaces to feed an external digital baseband signal into
the signal path.
Required Options
The equipment layout for applying an external baseband signal includes:
●
Option standard or wideband baseband generator (R&S SMW-B10/-B9) per signal
path
(incl. one digital interface per installed option)
●
Up to two options fading simulator (R&S SMW-B14)
(incl. one digital interface per installed option)
For more information, see data sheet.
Digital Baseband Input Settings