Rohde & Schwarz R&S SMW200A - Page 160

Signal Routing and System Configuration
R&S
®
SMW200A
160User Manual 1175.6632.02 ─ 30
The "Baseband Input Settings" dialog provides settings necessary to define the
used connector, and to adjust the signal parameters, like the sample rate and the
baseband input level.
Figure 4-11: Example: Baseband Input Settings in 1x4x4 configuration (standard baseband)
If the current instrument configuration uses Coupled sources, the dialog consists of
up to four side tabs, whereas the number of tabs corresponds to the number of
selected BB Signals (Tx Antennas). The tab name displays the baseband the set-
tings are related to and the connector the digital input signal is provided at.
5. To enable the input signal:
● Select "BB Input > On" or
● Select "BB Input > Baseband Input Settings > State > On".
Settings:
● General Settings................................................................................................... 161
● Sample Rate Settings........................................................................................... 162
● Input Level Settings...............................................................................................163
● Signal Monitoring Settings.................................................................................... 165
Digital Baseband Input Settings