Rohde & Schwarz R&S SMW200A - Page 162

Signal Routing and System Configuration
R&S
®
SMW200A
162User Manual 1175.6632.02 ─ 30
See also:
●
Description "CDMA2000
®
incl. EV-DV Digital Standard for R&S SMW"
●
Description "1xEV-DO Rev. A, Rev. B Digital Standard for R&S SMW"
Remote command:
[:SOURce<hw>]:BBIN:IQSWap[:STATe] on page 959
Connected Device
If the connection to the external device is properly established and signal transmission
is active, this parameter displays information on the instrument connected to the DIG
I/Q interface:
●
Name, serial number and port of the connected instrument
●
The transmitter sample rate, if supported by the transmitter
"None" indicates that no device is connected.
Remote command:
[:SOURce<hw>]:BBIN:CDEVice? on page 957
4.6.1.2 Sample Rate Settings
Option: R&S SMW-B10
Access:
► Select "BB Input > Digital I/Q In > Baseband Input Settings > Sample Rate".
Settings:
Sample Rate Source...................................................................................................162
Sample Rate Value......................................................................................................163
Sample Rate Source
Selects whether the sample rate is estimated based on the digital input signal or is a
manually entered value.
(See also Chapter 4.3.5, "Important Signal Parameters and Interface's Characteristics",
on page 119).
Digital Baseband Input Settings