Rohde & Schwarz R&S SMW200A - Page 167

Signal Routing and System Configuration
R&S
®
SMW200A
167User Manual 1175.6632.02 ─ 30
The "Baseband Input Settings" dialog provides settings necessary to define the
used connector, and to adjust the signal parameters, like the sample rate and the
baseband input level.
In this dialog, you access the settings the HS DIG I/Q connector. You recognize
the type of connector that is active by the used connector icon.
3. To set the input connector, select "BB Input > Interface > HS DIG I/Q"
4. To enable the input signal, set "Baseband Input Settings > State > On".
Settings:
● General Settings................................................................................................... 167
● Signal Input Settings............................................................................................. 169
4.6.2.1 General Settings
Access:
1. Select "BB Input > Digital I/Q In > Baseband Input Settings".
2. Select "BB Input > Interface > HS DIG I/Q"
Digital Baseband Input Settings