Signal Routing and System Configuration
R&S
®
SMW200A
170User Manual 1175.6632.02 ─ 30
Figure 4-13: Signal Input settings in wideband baseband with separate BB sources
Settings:
Channel Table............................................................................................................. 170
└ Number......................................................................................................... 170
└ Name............................................................................................................ 170
└ Sample Rate................................................................................................. 170
└ Crest Factor.................................................................................................. 171
└ Peak Level.................................................................................................... 171
└ Level............................................................................................................. 171
└ BB................................................................................................................. 171
Aggregated Link Sample Rate.................................................................................... 171
DIG IQ Auto Setting.................................................................................................... 171
Measurement Period...................................................................................................171
Auto Level Set.............................................................................................................172
Channel Table
Displays information on the up to 8 digital channels per HS DIG I/Q interface:
Number ← Channel Table
Subsequent number.
Name ← Channel Table
Channel indication, set by the transmitter.
Remote command:
[:SOURce<hw>]:BBIN:CHANnel<ch0>:NAME on page 958
Sample Rate ← Channel Table
Indicates the used sample rate per channel.
For information on the max. sample rate and the aggregated sample rate, depending
on the number of active channels, observe the indication Aggregated Link Sample
Rate.
Digital Baseband Input Settings
To Next Page
Loading...