Signal Routing and System Configuration
R&S
®
SMW200A
173User Manual 1175.6632.02 ─ 30
In the default instrument state (Standard mode), the block diagram displays the BBMM
connectors in a folded state. The digital output interfaces are inactive (gray LEDs).
1 32
Figure 4-14: Representation of the digital output interface DIG I/Q in standard mode
1 = mapped I/Q stream
2 = digital output interface state: gray = inactive; blue = active
3 = digital output connector name
1. Select the "BBMM 1/2" symbol to unfold the "I/Q Digital" block.
2. In Wideband baseband istrument, you access the settings of both, the DIG I/Q and
the HS DIG I/Q connectors in the same manner. You recognize the type of connec-
tor that is active by the used connector icon.
To change the output connector, select "System Config > Signal Outputs" = "Ana-
log & Digital (HS) or Digital Only (HS)".
3. To (re) route the I/Q streams to the digital outputs, select the "I/Q Stream Mapper"
block.
4. To enable the baseband signal at the digital outputs, select "Block Diagram > I/Q
Digital A or B > I/Q Digital > On".
5. To access the dialog box for configuring the digital output signal, select "I/Q Digital
> I/Q Digital Outputs".
To access and configure the "I/Q Digital Output" settings in "System Configura-
tion > Mode > Advanced"
The digital output connectors are located on the R&S SMW rear panel, see Figure 4-1.
In Advanced mode, the block diagram displays all digital output interfaces as one com-
mon connector symbol in folded state. The digital output interfaces are inactive (gray
LED).
2
1
Figure 4-15: Representation of the digital output interface DIG I/Q in advanced mode
I/Q Digital Output Settings
To Next Page
Loading...