Rohde & Schwarz R&S SMW200A - Page 176

Signal Routing and System Configuration
R&S
®
SMW200A
176User Manual 1175.6632.02 ─ 30
If R&S SGT is connected to the DIG I/Q interface of the R&S SMW, several parame-
ters set automatically.
Settings:
State............................................................................................................................176
Show Connector..........................................................................................................176
Sample Rate............................................................................................................... 176
└ Slow IQ State................................................................................................176
└ Common to all Channels...............................................................................177
└ Source...........................................................................................................177
└ Value.............................................................................................................177
Connected Device.......................................................................................................177
State
Activates/deactivates the digital I/Q output.
Remote command:
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:STATe on page 1146
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:STATe on page 1146
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
A blinking LED on the front/rear panel indicates the selected connector, too (see Chap-
ter 12.2.2.4, "Status Indicators", on page 718).
Sample Rate
Comprises the sample rate parameters:
Slow IQ State ← Sample Rate
Option: R&S SMW-K551
If "Digital Only" or "Digital Only Multiplexed" signals are generated, this parameter
shows whether a "Sample Clock Request" is enabled in the connected R&S EX-IQ-
Box.
I/Q Digital Output Settings