Signal Routing and System Configuration
R&S
®
SMW200A
192User Manual 1175.6632.02 ─ 30
Tip: Use the provided preview diagram and description to simplify the decision
process.
3. If necessary, adjust the "Baseband Source Configuration".
For example, to enable the instrument to calculate the required signals and
streams out of one baseband signal source, select "BB Source Config > Coupled
Sources"
Figure 4-20: Configuration example (Fading and Baseband Configuration > 1x4x4 and Coupled
Baseband Sources)
4. Execute "Apply" to trigger the instrument to adopt the signal routing.
The block diagram displays the configured signal routing.
Figure 4-21: Signal routing example (Fading and Baseband Configuration > 1x4x4 and Coupled
Baseband Sources)
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...