Signal Routing and System Configuration
R&S
®
SMW200A
195User Manual 1175.6632.02 ─ 30
Figure 4-22: Example of test setup: 1x4x4 MIMO with R&S
SMW and 2xR&S
SGS connected to the I/Q
OUT 1/2.
Blue circle = front panel connector
Gray circle = rear panel connector
Refer to "To connect instruments to the I/Q analog interface" on page 196 for a
description of how to configure the R&S SMW.
4.9.6 How to Connect and Configure External Instruments
See:
●
"To connect instruments to the I/Q analog interface" on page 196
●
"To connect instruments to the I/Q digital interface" on page 198
●
"To connect and configure an R&S SZU" on page 200
●
"To create a remote control sequence or modify the initialization sequence"
on page 203
You have already selected a MIMO scenario and have mapped the I/Q stream to the
output interfaces, see:
●
"To simulate complex MxN MIMO scenarios using the "Fading and Baseband Con-
figuration" settings" on page 191
●
Chapter 4.9.4, "How to Route the I/Q Streams to the Output Interfaces",
on page 193
How to Connect External Instruments and Configure the Signal Flow
To Next Page
Loading...