Rohde & Schwarz R&S SMW200A - Page 258

Configuring the Internal Baseband Source
R&S
®
SMW200A
258User Manual 1175.6632.02 ─ 30
Remote command:
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:DELay on page 1011
[:SOURce<hw>]:BB:ARBitrary:TRIGger:OUTPut<ch>:DELay on page 1069
[:SOURce<hw>]:BB:MCCW:TRIGger:OUTPut<ch>:DELay on page 1087
5.5.2.3 Clock Settings
Access:
► Select "Baseband > Custom Dig Mod > Clock".
The tab provides access to the settings necessary to select and configure the clock
signal, like the clock source and clock mode.
Settings:
Clock Source...............................................................................................................258
Clock Mode................................................................................................................. 258
Measured External Clock............................................................................................259
Clock Source
Selects the clock source.
●
"Internal"
The instrument uses its internal clock reference.
●
"External Local Clock"
Option: R&S SMW-B10
The instrument expects an external clock reference at the local T/M/C connector.
See also "Clock Signals" on page 227.
Remote command:
[:SOURce<hw>]:BB:DM:CLOCk:SOURce on page 1012
[:SOURce<hw>]:BB:ARBitrary:CLOCk:SOURce on page 1070
[:SOURce<hw>]:BB:MCCW:CLOCk:SOURce on page 1088
Clock Mode
Option: R&S SMW-B10
Sets the type of externally supplied clock.
Remote command:
[:SOURce<hw>]:BB:DM:CLOCk:MODE on page 1012
[:SOURce<hw>]:BB:ARBitrary:CLOCk:MODE on page 1070
[:SOURce<hw>]:BB:MCCW:CLOCk:MODE on page 1088
Common Functions and Settings in the Baseband Domain