Configuring the Internal Baseband Source
R&S
®
SMW200A
263User Manual 1175.6632.02 ─ 30
The remote commands required to define these settings are described in Chap-
ter 14.19.4.2, "SOURce:BB:DM Subsystem", on page 988.
Settings:
● General Settings................................................................................................... 263
● Trigger, Marker and Clock Setting.........................................................................265
● Data Source.......................................................................................................... 266
● Modulation Settings...............................................................................................271
● Filter Settings........................................................................................................ 274
● Power Ramp Control Settings...............................................................................276
● Data List Editor......................................................................................................279
● Control and Marker Lists Editor.............................................................................281
5.6.3.1 General Settings
Access:
► Select "Baseband > Custom Digital Mod".
This tab provides access to the default and the save/recall settings, and to a quick
selection of a digital modulation according to predefined communication standard.
Settings:
State............................................................................................................................264
Set To Default..............................................................................................................264
Save/Recall.................................................................................................................264
Set according to Standard...........................................................................................264
Generating Custom Digital Modulated Signals
To Next Page
Loading...