Rohde & Schwarz R&S SMW200A - Power Ramp Control Settings

Configuring the Internal Baseband Source
R&S
®
SMW200A
276User Manual 1175.6632.02 ─ 30
Remote command:
[:SOURce<hw>]:BB:DM:FILTer:PARameter:LPASs on page 997
[:SOURce<hw>]:BB:DM:FILTer:PARameter:LPASSEVM on page 997
[:SOURce<hw>]:BB:DM:FILTer:PARameter:APCO25Lsm:GAUSs on page 997
[:SOURce<hw>]:BB:DM:FILTer:PARameter:APCO25Lsm:LOWPass on page 997
Bandwidth
Determines the bandwidth of the cosine filter, so that the function in H(f) = 0 is fulfilled
for f >= (1 + rolloff)* bandwidth /2.
Remote command:
[:SOURce<hw>]:BB:DM:FILTer:PARameter:COSine:BANDwidth on page 997
Load User Filter
Calls the dialog "Select User Filter" for selecting a user-defined filter file with extension
*.vaf (see "User filter" on page 247). The dialog provides access to the standard file
management functions, like save, load, delete.
Remote command:
[:SOURce<hw>]:BB:DM:FLISt:SELect on page 1013
[:SOURce<hw>]:BB:DM:FLISt:CATalog? on page 1012
[:SOURce<hw>]:BB:DM:FLISt:DELete on page 1014
5.6.3.6 Power Ramp Control Settings
Access:
► Select "Baseband > Custom Digital Modulation > General > Power Ramp Control".
Generating Custom Digital Modulated Signals