Rohde & Schwarz R&S SMW200A - Page 277

Configuring the Internal Baseband Source
R&S
®
SMW200A
277User Manual 1175.6632.02 ─ 30
The dialog comprises the settings used to configure the power ramping, like the source
of the control signals, the form of the ramp function and the applied attenuation.
See also "Power Ramping and Level Attenuation" on page 229.
Power ramping is possible up to a symbol rate of 5 MHz. A higher symbol rate disables
the power ramping automatically and an error message is output.
Settings:
State............................................................................................................................277
Source.........................................................................................................................277
Ramp Function............................................................................................................278
Ramp Time..................................................................................................................278
Rise Delay...................................................................................................................278
Fall Delay.................................................................................................................... 278
Attenuation..................................................................................................................278
In Baseband Only........................................................................................................278
State
Enables/disables power ramping.
Remote command:
[:SOURce<hw>]:BB:DM:PRAMp[:STATe] on page 1004
Source
Defines the source for the power ramp control signals.
Generating Custom Digital Modulated Signals