Rohde & Schwarz R&S SMW200A - Page 308

Configuring the Internal Baseband Source
R&S
®
SMW200A
308User Manual 1175.6632.02 ─ 30
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency on page 1031
Samples per Period
Enters the number of sample values required from the sine wave per period.
The maximum allowed value is determined by the maximum ARB clock rate (see data
sheet) and the selected frequency.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles on page 1032
Phase Offset Q
Enters the phase offset of the sine-wave signal on the Q channel relative to the sine-
wave signal on the I channel.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe on page 1031
Generate Signal File
Generates a signal and saves it as a waveform file on the hard disk. Use the standard
"File Select" function to save the file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed on page 1032
Generate Signal RAM
Generates a signal and uses it as output straight away. The instrument saves the file
using a predefined filename.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate on page 1032
5.7.3.3 Rectangular Test Signal
Access:
1. Select "Baseband > ARB > General > Test Signal Form > Rect".
2. Select "Create Test Signal".
Using the Arbitrary Waveform Generator (ARB)