Getting Started
R&S
®
SMW200A
32User Manual 1175.6632.02 ─ 30
► Connect the LAN socket via an RJ-45 cable to the LAN.
By default, the R&S SMW is configured to use DHCP (dynamic host configuration pro-
tocol) and no static IP address is configured.
If switched on and connected to the LAN, the R&S SMW displays the address informa-
tion on the screen.
Figure 3-1: IP address indication on the screen (example)
See also Chapter 13.6, "Connecting the Instrument to the Network (LAN)",
on page 803.
3.1.8 Connecting USB Devices
You can connect or disconnect all USB devices from the R&S SMW during operation.
To connect USB storage devices
USB storage devices, such as memory sticks, allow easy data transfer from/to the
R&S SMW. You can also use them for firmware updates.
► Connect the USB storage device to any of the USB connectors.
To connect USB devices with external power supply
1.
NOTICE! Connected devices with external power supply can feed back current into
the 5 V power supply of the USB interface and thus damage the R&S SMW.
Ensure that there is no connection between the positive pole of the power supply
and the +5 V power pin of the USB interface (VBUS).
2. Connect the USB storage device to any of the USB connectors.
To connect a keyboard
► Connect the keyboard to any of the USB connectors.
When connected, the R&S SMW detects the keyboard automatically. A detected key-
board has the default layout English – US.
To connect a mouse
► Connect the mouse to any of the USB connectors.
When connected, the R&S SMW detects the mouse automatically.
Preparing for Use
To Next Page
Loading...