Getting Started
R&S
®
SMW200A
35User Manual 1175.6632.02 ─ 30
3.1.10 Connecting to LO In/Out
"LO In/Out" connectors are Subminiature Version A (SMA) connectors.
The connector is located on the rear panel.
Follow the instructions in "To connect to screwable connectors" on page 33.
See also Chapter 8.6, "Local Oscillator Coupling", on page 482.
3.1.11 Connecting to REF IN/REF OUT
The connector is located on the rear panel.
To connect to REF IN/REF OUT (reference < 1 GHz)
For connection, the R&S SMW provides BNC connectors.
► Follow the instructions in "To connect to non-screwable connectors (BNC)"
on page 33.
To connect to REF IN/REF OUT (reference = 1 GHz)
For connection, the R&S SMW provides SMA connectors.
► Follow the instructions in "To connect to screwable connectors" on page 33.
3.1.12 Connecting to HS DIG I/Q
The HS DIG I/Q connector comprises a QSFP+ (Quad Small Form-factor Pluggable)
socket, that has two components: a QSFP+ cage and a QSFP+ connector. The QSFP+
cable is equipped with the QSFP+ plug.
1
2
3
1
= QSFP+ plug
2 = QSFP+ cage
3 = QSFP+ connector
The connector is located on the rear panel.
Preparing for Use
To Next Page
Loading...