Rohde & Schwarz R&S SMW200A - Generating Multi-Segment Waveform Files; Reducing the Crest Factor

Configuring the Internal Baseband Source
R&S
®
SMW200A
351User Manual 1175.6632.02 ─ 30
The R&S SMW processes the waveform file and generates an AWGN signal.
Settings:
Samples...................................................................................................................... 351
Generate Signal RAM................................................................................................. 351
Samples
Sets the number of samples generated for the AWGN waveform.
The maximum number of samples depends on the installed ARB options.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:AWGN:SAMPles on page 1033
Generate Signal RAM
Generates a signal and uses it as output straight away. The instrument saves the file
with a predefined name.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:AWGN:CREate on page 1033
5.9 Reducing the Crest Factor
Reducing the crest factor of waveforms is a function that requires the additional option
Crest Factor Reduction (R&S SMW-K548).
See user manual R&S SMW-K548 Crest Factor Reduction.
5.10 Generating Multi-Segment Waveform Files
Modern chip technologies implement several communication standards within one chip
and rise special verification and test requirements. To fulfill the requirements of these
test systems and to enable rapid alternation between different waveforms with differing
Generating Multi-Segment Waveform Files