Configuring the Internal Baseband Source
R&S
®
SMW200A
355User Manual 1175.6632.02 ─ 30
Figure 5-29: Marker priority used by assigning of marker signals to a hardware connector
5.10.2.5 Impact of the Trigger Settings and Next Segment Settings
The ARB dialog is equipped with the standard (regular) trigger settings. These settings
are provided for triggering of the composed multi-segment waveform as a sequence,
i.e. as one file. The functions provided in the "Trigger" tab and their effect are descri-
bed in Chapter 5.5.1.3, "Baseband Trigger Signals", on page 235.
This section focuses on the additional settings provided for triggering of the individual
segments building the composed multi-segment waveform. These settings are enabled
and visible only if a multi-segment waveform is loaded for processing. The settings are
grouped in the "Multi Segment Waveform Options/Next Segment Trigger In" section.
The Figure 5-30 illustrates how trigger events affect the processing of the multi-seg-
ment waveforms.
Figure 5-30: Principle of segment triggering
Generating Multi-Segment Waveform Files
To Next Page
Loading...