Rohde & Schwarz R&S SMW200A - Multi-Segment Settings

Configuring the Internal Baseband Source
R&S
®
SMW200A
357User Manual 1175.6632.02 ─ 30
Table 5-20: Transition examples
Next Segment switching Next Segment Seamless
Understanding the Trigger Examples
A simplified diagram in the ARB dialog is intended to explain the effect of the triggering
on the signal processing. The currently enabled settings for trigger and next segment
mode are considered.
The curves plotted in the dialog are textbook examples, "not measured" waveforms.
They are intended to visualize the trigger and the next segment settings more clearly.
●
The triangle on the top line denotes a trigger event. A filled triangle on the bottom
line denotes a next segment event.
●
A green sine wave (or other shape) over a full period indicates one replay cycle of
a segment. A shorter example signal indicates a replay cycle which was interrup-
ted, e.g. due to a next segment event (compare the two graphics in Table 5-21).
Table 5-21: Trigger examples in the ARB dialog
"Next Segment Mode = Next Segment" "Next Segment Mode = Next Segment Seamless"
5.10.3 Multi-Segment Settings
Access:
1. Select "Baseband > ARB > General > Create Multi Segment".
Generating Multi-Segment Waveform Files