Configuring the Internal Baseband Source
R&S
®
SMW200A
358User Manual 1175.6632.02 ─ 30
The "ARB: Multi Segment" dialog enables direct assignment of waveforms to the
multiple segments, adjusting the clock, level, and marker settings of the composed
waveform and selecting the output file.
For description on the provided settings, refer to:
Chapter 5.10.3.1, "Setting for Handling the Multi-Segment Files and Output File
Settings", on page 359,
Chapter 5.10.3.2, "Segment Table", on page 361 and
Chapter 5.10.3.3, "Level / Clock / Marker Settings", on page 363
2. Select "ARB: Multi Segment > General" > "Create and Load Output File" to store
and load current multi-segment file.
3. Select "Multi Segment" > "Sequencing List" to access the settings for configuring
a sequencing "Play List" for fast automatic processing of the multi-segment wave-
form.
For a description of the provided settings, refer to Chapter 5.10.3.4, "Multi-Seg-
ment Waveform Sequencing", on page 365.
4. Select "Baseband > ARB > General".
The "Load Waveform" confirms that the current multi-segment file is loaded (file-
name as defined with "Output File").
Note: The provided settings depend on the current waveform.
The "Sequencing List" function for instance requires that:
● Multi segment file is created, i.e. you have executed"Create Output File/
Create and Load Output File".
● "Sequence Table" contains more than one segment.
5. Select "Baseband > ARB > Trigger In (MSW)".
For a description of the provided settings, refer to Chapter 5.10.3.5, "Next Segment
Trigger In Settings", on page 369.
6. Select "Baseband > ARB > General > State > On" to process the configured multi-
segment waveform.
The remote commands required to define these settings are described in Chap-
ter 14.19.4.3, "SOURce:BB:ARBitrary Subsystem", on page 1019.
Generating Multi-Segment Waveform Files
To Next Page
Loading...