Configuring the Internal Baseband Source
R&S
®
SMW200A
360User Manual 1175.6632.02 ─ 30
Save List/Save List As...
Saves the current entries of the Segment Table in a configuration list (file), including
the level mode, clock mode, segment marker mode, and output filename settings.
See also Chapter 5.10.2.3, "File Concept", on page 353.
Consider also the following remote control commands:
●
To define the configuration file (*.inf_mswv) used by the calculation of the output
file:
– [:SOURce<hw>]:BB:ARBitrary:WSEGment:CREate
– [:SOURce<hw>]:BB:ARBitrary:WSEGment:CLOad
●
To define the filename of the output waveform file (*.wv):
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe
Remote command:
n.a.
Sequencing List
Accesses the dedicated dialog for configuring the associated play lists, see Chap-
ter 5.10.3.4, "Multi-Segment Waveform Sequencing", on page 365.
This function is enabled, if a multi segment file is created or created and loaded.
Remote command:
n.a.
Comment
Adds a comment to the composed multi-segment file.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:COMMent on page 1045
Output file
Accesses the standard "File Select" dialog function and requests the filename for the
multi-segment waveform to be calculated.
An output filename is required for further processing of the multi-segment waveform:
●
For the internal storage triggered by the "Save List" function
●
For the calculation and creation of the multi-segment waveform, triggered by the
"Create" or "Create and Load" function.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:CONFigure:OFILe on page 1045
Create/Create and Load
●
"Create"
Creates a multi-segment waveform using the current entries in the Segment Table.
●
"Create and Load"
Creates a multi-segment waveform and loads it in the ARB generator.
The R&S SMW stores the multi-carrier waveform as file with filename as specified with
parameter Output file.
Depending on the configuration of the multi-carrier waveform, calculation takes some
time. Use the "Abort" function, to interrupt the calculation.
Generating Multi-Segment Waveform Files
To Next Page
Loading...