Rohde & Schwarz R&S SMW200A - Page 367

Configuring the Internal Baseband Source
R&S
®
SMW200A
367User Manual 1175.6632.02 ─ 30
All segments in a “play list” must have the same clock rate.
Settings:
● General Settings................................................................................................... 367
● Sequencing Play List Settings...............................................................................368
General Settings
Access:
► Select "Baseband > ARB > General > Multi Segment > Sequencing List...".
Settings:
New/Load Sequencing List......................................................................................... 367
Save List/Save List As................................................................................................ 367
Sequencing List...........................................................................................................367
Assigned to Multi Seg. Waveform............................................................................... 367
New/Load Sequencing List
Accesses the standard "Select Sequencing List" function to define the name of the new
play list file or select of an existing one.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:WSEGment:SEQuence:SELect on page 1040
Save List/Save List As
Saves the current entries of the table in a play list file. Play list files have the file exten-
sion *.wvs.
The default filename of the play list file is the same as the multi-segment waveform file-
name, but it can be changed.
Sequencing List
Displays the name of the selected sequencing list file, i.e. the file with the “play list” set-
tings (see Chapter 5.10.2.3, "File Concept", on page 353).
Remote command:
n.a.
Assigned to Multi Seg. Waveform
Displays the name of the multi-segment waveform file the current sequencing list file is
assigned to.
Remote command:
n.a.
Generating Multi-Segment Waveform Files