Rohde & Schwarz R&S SMW200A - Page 403

Configuring the Internal Baseband Source
R&S
®
SMW200A
403User Manual 1175.6632.02 ─ 30
Settings:
Table Setup Assistant..................................................................................................403
└ Carrier Start/Stop..........................................................................................403
└ Carrier State..................................................................................................403
└ Power Start................................................................................................... 404
└ Power Step................................................................................................... 404
└ Phase Start................................................................................................... 404
└ Phase Step................................................................................................... 404
└ Accept...........................................................................................................404
Carrier Table................................................................................................................404
Table Setup Assistant
Enables joint configuration of selectable range of carriers.
Carrier Start/Stop ← Table Setup Assistant
Defines the start/stop index of the carrier range to which the following settings are
intended to apply.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt on page 1081
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP on page 1081
Carrier State ← Table Setup Assistant
Switches the carriers in the carrier range on/off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe on page 1082
Generating Multi-Carrier Continuous Wave Signal