Rohde & Schwarz R&S SMW200A - Activating RF Signal Output

Configuring the RF Signal
R&S
®
SMW200A
460User Manual 1175.6632.02 ─ 30
Menu item Content Described in ...
Amplitude / Frequency / Phase
Modulation
AM, FM and PhiM settings. Chapter 8.8.4, "Modulation Set-
tings", on page 540
Pulse Modulation
Pulse modulation settings:
●
General settings
●
Pulse generator settings
●
Graphical display of the
pulse signal
Chapter 8.8.4.1, "Pulse Modula-
tion Settings", on page 540
Modulation Source
Signal sources for the LF signal:
●
Internal signal generators
●
Externally applied LF signal
●
LF signal shapes
Chapter 8.8.2, "Modulation Sig-
nals", on page 531 and Chap-
ter 8.8.2.4, "Modulation Signal
Waveforms", on page 537
LF Output Configures the LF signal for out-
put.
Chapter 8.8.4.6, "Output Set-
tings", on page 557
Sweep / List Information on configuring an RF
signal with varying frequencies or
amplitudes, either in Sweep or
List Mode.
Chapter 8.7, "Varying the RF Sig-
nal in List or Sweep Mode",
on page 491
RF Frequency / RF Level Sweep /
LF Frequency Sweep
Sweep mode settings. Chapter 8.7.5, "Sweep Mode Set-
tings", on page 508
List Mode List mode settings. Chapter 8.7.6, "List Mode Set-
tings", on page 517
8.3 Activating RF Signal Output
Per default, the RF output signal is deactivated. The previous state is restored when
the signal is reactivated.
To activate the RF output
1. Configure the RF signal as required.
Set, for example, the frequency and level values.
2. Activate the RF output in one of the following ways:
a) Select "Level > RF ON > On"
b) Press the [RF ON/OFF] key at the front panel.
3. In the block diagram, observe the color of the "RF On" icon.
The blue color indicates that the RF output is activated.
RF State/RF ON..........................................................................................................460
RF output impedance..................................................................................................461
RF State/RF ON
Activates or deactivates the RF output.
Acts as the [RF ON/OFF] key.
Activating RF Signal Output