Rohde & Schwarz R&S SMW200A - RF Level Settings

Configuring the RF Signal
R&S
®
SMW200A
466User Manual 1175.6632.02 ─ 30
8.4.2 RF Level Settings
Access:
1. Select "RF" > "RF Level" > "Level".
In the "RF Level" dialog, you can configure the offset-free level, the level limit, and
the step width for varying the level with the rotary knob.
2. Select "User Variation" to set the step width to be used when setting the RF level
using the rotary knob.
The remote commands required to define the settings are described in Chap-
ter 14.19.16, "SOURce:POWer Subsystem", on page 1188.
Settings
RF State/RF ON..........................................................................................................467
Amplitude.................................................................................................................... 467
Digital Attenuation.......................................................................................................467
Mode........................................................................................................................... 468
Configuring RF Frequency and Level