Rohde & Schwarz R&S SMW200A - Page 467

Configuring the RF Signal
R&S
®
SMW200A
467User Manual 1175.6632.02 ─ 30
Setting Characteristics................................................................................................ 468
Level Range................................................................................................................469
Readjust......................................................................................................................470
Limit.............................................................................................................................470
Offset...........................................................................................................................470
User Variation..............................................................................................................470
└ Variation Active............................................................................................. 470
└ Variation Step................................................................................................471
RF State/RF ON
Activates or deactivates the RF output.
Acts as the [RF ON/OFF] key.
Remote command:
:OUTPut<hw>[:STATe] on page 886
:OUTPut:ALL[:STATe] on page 885
Amplitude
Sets the level of the RF signal.
The value is offset-free and corresponds to the level at the RF A/RF B connector.
See Chapter 8.4.4.1, "Displayed RF Frequency and Level Values with Downstream
Instruments", on page 472.
Note: Suppressed values in the status bar
For security concerns or certain operating modes, you can hide the frequency and
level display in the status bar.
●
The display has been disabled for security reasons.
See:
– Annotation Frequency
– Annotation Amplitude
The display is disabled when:
– List mode is running, see Chapter 8.7, "Varying the RF Signal in List or Sweep
Mode", on page 491.
– Digital only signals are generated, see the user manual "R&S SMW-K551 Gen-
eration of Digital "Slow IQ" Signals"
Remote command:
[:SOURce<hw>]:POWer:POWer on page 1195
Note: The SCPI command [:SOURce<hw>]:POWer[:LEVel][:IMMediate][:
AMPLitude] sets the level of the "Level" display.
This means, the level containing offset.
Digital Attenuation
Attenuates or raises the level of the internal, digitally modulated I/Q baseband signals,
and thus the level of the RF signal accordingly.
Configuring RF Frequency and Level