Rohde & Schwarz R&S SMW200A - Sweep Mode Settings

Configuring the RF Signal
R&S
®
SMW200A
508User Manual 1175.6632.02 ─ 30
This mode is optimized for maximum signal quality, and is useful if dwell times higher
than 2 ms are sufficient.
8.7.5 Sweep Mode Settings
This section lists the settings of all available sweep modes.
Access:
1. Select "RF" > "Sweep/List" > "RF Frequency Sweep"
2. Select "RF" > "Sweep/List" > "RF Level Sweep"
3. Select "RF" > "Sweep/List" > "RF Combined Sweep"
4. Select "RF" > "Sweep/List" > "LF Frequency Sweep"
The sweep modes use the similar parameters to be configured. Thus, the descrip-
tion comprises the settings of the three dialogs, "RF Frequency Sweep", "RF Level
Sweep" and "LF Frequency Sweep". If parameters relate to only particular modes,
they are pointed out.
The remote commands required to define these settings are described in:
●
Chapter 14.19.6, "SOURce:FREQuency Subsystem", on page 1124
●
Chapter 14.19.16, "SOURce:POWer Subsystem", on page 1188
●
Chapter 14.19.19, "SOURce:SWEep Subsystem", on page 1205
●
Chapter 14.19.11, "SOURce:LFOutput Subsystem", on page 1152
Settings
● General Sweep Settings....................................................................................... 508
● Frequency Range Settings....................................................................................513
● Level Range Settings............................................................................................515
8.7.5.1 General Sweep Settings
Access:
► Select, for example, "RF" > "Sweep/List" > "RF Frequency Sweep".
Table 8-8: General settings dialog: Examples of RF Frequency and RF Combined Sweep dialogs
> "RF Frequency Sweep" > "RF Combined Sweep"
Varying the RF Signal in List or Sweep Mode