Rohde & Schwarz R&S SMW200A - Page 509

Configuring the RF Signal
R&S
®
SMW200A
509User Manual 1175.6632.02 ─ 30
Settings
State (RF frequency sweep)....................................................................................... 509
State (RF level sweep)................................................................................................509
State (RF frequency / level sweep).............................................................................509
State (LF frequency sweep)........................................................................................509
Current Frequency...................................................................................................... 510
Current Level...............................................................................................................510
Mode........................................................................................................................... 510
Retrace........................................................................................................................511
Shape.......................................................................................................................... 511
Spacing........................................................................................................................511
Dwell Time...................................................................................................................512
Trigger Slope...............................................................................................................512
Execute Single Sweep................................................................................................ 512
Show Connector..........................................................................................................513
Reset Sweep...............................................................................................................513
State (RF frequency sweep)
Activates RF frequency sweep signal generation.
Note: Active RF frequency, RF level or RF combined sweep modes deactivate the LF
sweep or List mode and vice versa.
Remote command:
[:SOURce<hw>]:FREQuency:MODE on page 1128
State (RF level sweep)
Activates RF level sweep signal generation.
Note: Active RF frequency, RF level or RF combined sweep modes deactivate the LF
sweep or List mode and vice versa.
Remote command:
[:SOURce<hw>]:POWer:MODE on page 1194
State (RF frequency / level sweep)
Activates the RF frequency / level sweep signal generation.
Note: Active RF frequency, RF level or RF combined sweep modes deactivate the LF
sweep or List mode and vice versa.
Remote command:
[:SOURce<hw>]:FREQuency:MODE on page 1128
[:SOURce<hw>]:POWer:MODE on page 1194
State (LF frequency sweep)
Status of the LF frequency sweep signal.
You find this parameter in two dialogs:
●
"LF Frequency Sweep" turns on/off the signal generation.
See Sweep Mode Settings for access.
●
"Analog Modulation Sources" displays the current state (read-only). If it is turned
on, this dialog provides the varying sweep frequency, see Current Frequency.
Varying the RF Signal in List or Sweep Mode