Getting Started
R&S
®
SMW200A
51User Manual 1175.6632.02 ─ 30
LF OUT x
Option: R&S SMW-B13/-B13T
Output for internal LF generator signal.
Note: The output of the internal LF signal and the analog I/Q signal use the same
physical connectors. Therefore, consider that you cannot output both signals simulta-
neously.
See the data sheet and in the user manual, section Chapter 8.8, "Analog Modulations",
on page 529.
I/Q, I/Q Bar
BNC connector for output of direct (single-ended) or differential analog I/Q signals.
Note: The R&S SMW also assigns the internal signal of the LF generator to the I out-
put connector.
Therefore, consider that you cannot output the analog I/Q signal and the internal LF
signal at the same physical connector simultaneously.
Use the connectors for connections as follows:
●
I/Q connectors: Direct (single-ended) or positive differential output of analog I/Q
signals
●
I/Q Bar connectors: Negative differential output of analog I/Q signals
The number of connectors depends on the installed baseband options:
●
Standard baseband (R&S SMW-B10 and R&S SMW-B13T)
Two single-ended analog and two differential outputs.
Output of differential signal requires option R&S SMW-K16.
●
Wideband baseband (R&S SMW-B9 and R&S SMW-B13XT)
Two single-ended analog or one differential output. Differential and single-ended
signals cannot be output at the same time.
Output of differential signal requires option R&S SMW-K17.
How to:
●
"To connect instruments to the I/Q analog interface" on page 196
●
"To connect instruments to the I/Q digital interface" on page 198
ADV DATA/CTRL
Option: R&S SMW-B9/-B13XT and R&S SMW-K503/-K504
Interface for exchanging of external data and control signals.
See user manual R&S SMW-K501/-K502/-K503/-K504 Extended and Real-Time
Sequencing, Real-Time Control Interface.
ADV TRIG, ADV CLK
Option: R&S SMW-B9/-B13XT
Input and output for synchronization signal in multi-instrument setups.
See also Chapter 10, "Multi-Instrument Setups", on page 639.
HS DIG I/Q
Option: R&S SMW-B9/-B13XT
Connectors for the input/output of high-speed digital I/Q signals, for example, from and
to Rohde & Schwarz instruments.
Instrument Tour
To Next Page
Loading...