Configuring the RF Signal
R&S
®
SMW200A
520User Manual 1175.6632.02 ─ 30
Run Mode
Selects whether the instrument generates the signal by processing the list directly, or
by learning and replaying the data.
"Learned (Frozen RF Settings)"
Generates the signal with the previously learned and stored data from
the temporary memory.
See "Learn List Mode Data list processing mode" on page 507.
"Live"
Generates the signal directly from the database.
The instrument reads the pairs of values from the list, calculates the
hardware settings and generates the signal immediately.
See "Live list processing mode" on page 507.
Remote command:
[:SOURce<hw>]:LIST:RMODe on page 1172
Learn List Mode Data
Reads the settings from the list data table and calculates the associated hardware set-
tings. The learned data is stored in the temporary memory.
See also "When to use the "Learn List Mode Data" function" on page 507.
Remote command:
[:SOURce<hw>]:LIST:LEARn on page 1172
Trigger Slope
For "Mode = Extern Step/Single", selects the polarity of the active slope of an applied
instrument trigger.
Trigger signal is expected at the INST TRIG x connector.
"Positive"
The rising edge of the trigger signal triggers the instrument.
"Negative"
The falling edge of the trigger signal triggers the instrument.
Remote command:
[:SOURce<hw>]:INPut:TRIGger:SLOPe on page 1136
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
A blinking LED on the front/rear panel indicates the selected connector, too (see Chap-
ter 12.2.2.4, "Status Indicators", on page 718).
Reset
Resets the list to the starting point.
Remote command:
[:SOURce<hw>]:LIST:RESet on page 1176
Execute Single
Manually starts list processing in "Single" mode.
Remote command:
[:SOURce<hw>]:LIST:TRIGger:EXECute on page 1173
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...