Rohde & Schwarz R&S SMW200A - Page 522

Configuring the RF Signal
R&S
®
SMW200A
522User Manual 1175.6632.02 ─ 30
8.7.6.3 Import/Export Settings
Access:
1. Select "RF" > "Sweep/List" > "List Mode".
2. Select "List Mode Data" > "Im-/Export".
The "Im-/Export" dialog provides the parameters for importing or exporting files with
user data in standard ASCII *.txt or *.csv file format.
The table separators and the decimal floating point numbers are customizable.
Since you need to determine the same parameters for all standard ASCII file formats,
the settings of these dialogs are similar to the settings of user correction, for example.
Therefore, Chapter 8.9.3.4, "Import/Export List Files", on page 579 describes the set-
tings in general.
Settings
Mode........................................................................................................................... 522
ASCII File Settings......................................................................................................522
Select (ASCII) Source/Select (ASCII) Destination...................................................... 523
Select Source/Select ASCII Destination..................................................................... 523
Import / Export.............................................................................................................523
Mode
Selects import or export of a data list file. The provided parameters vary according to
the selected mode.
Remote command:
[:SOURce<hw>]:LIST:DEXChange:MODE on page 1179
[:SOURce<hw>]:CORRection:DEXChange:MODE on page 1121
ASCII File Settings
Defines the format and the separators of the associated data file.
Varying the RF Signal in List or Sweep Mode