Configuring the RF Signal
R&S
®
SMW200A
526User Manual 1175.6632.02 ─ 30
"Frequency /Hz"
Sets the frequency values.
Remote command:
[:SOURce<hw>]:LIST:FREQuency on page 1170
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency on page 1116
"Power /dBm" (list mode data table)
Sets the level values.
Remote command:
[:SOURce<hw>]:LIST:POWer on page 1173
"Correction Value /dBm" (user correction data table)
Sets the level values.
Remote command:
[:SOURce<hw>]:CORRection:CSET:DATA:POWer on page 1117
"Dwell /s"
In list mode, sets the dwell time values.
Remote command:
[:SOURce<hw>]:LIST:DWELl:LIST on page 1169
Data handling keys
Standard functions for file and data handling.
Go To ← Data handling keys
Selects a row for editing.
Edit ← Data handling keys
Enables you to insert, or delete a row or ranges within a list, and provides access to a
dialog for automatic filling, see "Fill..." on page 526.
Fill with Sensor ← Data handling keys
Opens a dialog to configure the automatic filling of user correction data with an R&S
NRP power sensor. Available in UCOR mode only.
See Chapter 8.9.3.3, "Fill with Sensor", on page 578
Save As/Save ← Data handling keys
Stores the list in a file with user-defined name and predefined file extension. To save a
copy or create a file, use the "Save as" function.
Fill...
Provides parameters for filling a table automatically with user-defined values.
Varying the RF Signal in List or Sweep Mode
To Next Page
Loading...