Configuring the RF Signal
R&S
®
SMW200A
547User Manual 1175.6632.02 ─ 30
Remote command:
[:SOURce<hw>]:AM:DEViation:MODE on page 968
Total Depth ← AM settings
Sets the sum of the signal Depth for path 1 and path 2 in per cent when using com-
bined sources and Deviation Mode > Fixed Total.
Provided both signal paths are turned on, the depth of both paths always sum up to the
value of the total depth.
Behavior when changing any depth settings:
●
Changing the total depth adjusts the depths of both paths proportionally.
●
Changing the depth of one path adjusts the depth of the other path. The sum
always results in the set total depth.
Remote command:
[:SOURce<hw>]:AM:DEPTh:SUM on page 968
Ratio Path2/Path1 ← AM settings
Sets the deviaton ratio of the signal depth for path 2 to path 1 in per cent when using
combined sources.
Remote command:
[:SOURce<hw>]:AM:RATio on page 969
8.8.4.3 Pulse Generator Settings
Access:
► Select "RF > Analog Modulation > Pulse Generator".
The "Pulse Generator" tab contains the settings for creating the pulse modulation
signal internally.
Analog Modulations
To Next Page
Loading...