Configuring the RF Signal
R&S
®
SMW200A
551User Manual 1175.6632.02 ─ 30
Pulse Delay
Sets the pulse delay. The pulse delay determines the time that elapses after a trigger
event before pulse modulation starts. The pulse delay is not effective for double pulse
generation.
Remote command:
[:SOURce<hw>]:PULM:DELay on page 981
Double Pulse Delay
Sets the delay from the start of the first pulse to the start of the second pulse.
Remote command:
[:SOURce<hw>]:PULM:DOUBle:DELay on page 982
Pulse Output State
Activates the output of the pulse modulation signal.
Remote command:
[:SOURce<hw>]:PGENerator:OUTPut[:STATe] on page 1186
Pulse Output Polarity
Sets the polarity of the pulse output signal.
Remote command:
[:SOURce<hw>]:PGENerator:OUTPut:POLarity on page 1186
Set Global Connector for Pulse Modulation
Routes the pulse input signal by default to the global user connector USER4 ("Pulse In
A/B"), and correspondingly the pulse output signal to USER5 ("Pulse Out A/B").
See also Table 12-1 in Chapter 12.2.2.1, "Global Connectors", on page 715.
8.8.4.4 Pulse Graph
Access:
► Select "RF" > "Analog Modulation" > "Pulse Modualtion > Pulse Graph".
The pulse graph is the graphical representation of the current pulse signal.
Analog Modulations
To Next Page
Loading...