Rohde & Schwarz R&S SMW200A - Page 553

Configuring the RF Signal
R&S
®
SMW200A
553User Manual 1175.6632.02 ─ 30
●
"Zoom Out" for the reverse operation.
8.8.4.5 AM, FM and PhiM Modulation Sources
Access:
► Select "RF > Analog Modulation > Modulation Source...".
In the "Sources" tab, you can configure an LF modulation signal for performing
analog modulations. It includes the setting parameters of the internal LF-and multi-
function generators, the noise generator, and an external signal source.
To select an external signal, you can directly access the settings of the Connectors
dialog.
The remote commands required to define these settings are described in Chap-
ter 14.19.11, "SOURce:LFOutput Subsystem", on page 1152.
Source > LF Generator Settings
Access:
► Select "RF" > "Analog Modulation" > "Modulation Source... > LF Generator".
Analog Modulations