Rohde & Schwarz R&S SMW200A - Page 555

Configuring the RF Signal
R&S
®
SMW200A
555User Manual 1175.6632.02 ─ 30
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:PERiod on page 1160
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:PERiod on page 1160
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:PERiod on page 1159
Pulse Width
Sets the pulse duration of the generated pulse signal.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:WIDTh on page 1159
Pulse Duty Cycle
Sets the ratio between the pulse duration and the pulse period in percent.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:DCYCle on page 1158
Triangle Rise
Sets the time required for the triangle signal to change from low level to high level.
See also Modulation Signal Waveforms.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRIangle:RISE on page 1161
Trapezoid Rise / Fall
Sets the time required for the trapezoid signal to change from low level to high level,
and vice versa.
See Modulation Signal Waveforms.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:RISE on page 1160
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:FALL on page 1159
Trapezoid High
Sets how long the trapezoid signal is at high level.
Remote command:
[:SOURce<hw>]:LFOutput<ch>:SHAPe:TRAPeze:HIGH on page 1160
Analog Modulations