Rohde & Schwarz R&S SMW200A - Page 558

Configuring the RF Signal
R&S
®
SMW200A
558User Manual 1175.6632.02 ─ 30
In the "Output" tab, you can configure the signal at the LF output, determine the
output voltage or add a DC offset.
LF Output Settings
Access:
► Select "RF > Output > LF Output".
Settings:
State............................................................................................................................558
Source.........................................................................................................................558
Output Voltage............................................................................................................ 559
DC-Offset.................................................................................................................... 559
Show Connector..........................................................................................................559
State
Activates the output of the LF signal.
Remote command:
[:SOURce]:LFOutput<ch>[:STATe] on page 1157
Source
Determines the LF signal to be synchronized of the corresponding path.
"LF Generator A1/2, B1/2"
Selects one of internally generated LF signals.
"AM A/B"
Selects the AM signal.
"FM/ΦM A/B"
Selects the signal also used by the frequency or phase modulations.
"Noise Generator A/B"
Selects the internally generated noise signal.
"External 1/2"
Selects an externally supplied LF signal
Remote command:
[:SOURce]:LFOutput<ch>:SOURce on page 1157
Analog Modulations