Configuring the RF Signal
R&S
®
SMW200A
560User Manual 1175.6632.02 ─ 30
Remote command:
[:SOURce<hw>]:NOISe:LEVel<ch>[:ABSolute]? on page 1182
8.8.4.7 Overview
Access:
► Select "RF" > "Analog Modulation" > "Modulations > Overview".
Blue color
= Active output signal (AM and FM)
Gray color = Inactive output signal (LF Out)
Miniature graph = Indicates an active source
Connectors = Indicate a connector (e.g. external signal) is involved in the path of the signal
The "Overview" tab is an interactive diagram that indicates the active modulations
and the signal being output.
Here you can:
● Select the output signal ("LF Out") per path; the setting acts as the parameter
"LF Output Source"
● Select the source for each modulation and modulation path; the setting acts as
the parameter "Source"
● Activate modulation per path; the setting acts as the parameter "State"
To generate a two-tone signal composed form the two paths of the same modu-
lation type, activate both paths.
● Activate "FM" or "PhiM"; the two modulations are mutually exclusive.
See:
● Chapter 8.8.2.3, "Assigning the LF Signal to the Output", on page 532 for
details
● Chapter 8.8.4, "Modulation Settings", on page 540 for description of the related
settings
Analog Modulations
To Next Page
Loading...