Rohde & Schwarz R&S SMW200A - Page 573

Configuring the RF Signal
R&S
®
SMW200A
573User Manual 1175.6632.02 ─ 30
8.9.3.1 User Correction Settings
Access:
1. Select "RF" > "RF Level" > "User Correction".
2. If you already have created a file with user correction data:
a) Select "UCOR Data > navigate to the file *.uco > Select".
b) Proceed with step 4.
3. If you need to create a file:
a) Select "UCOR Data > New".
b) Enter the filename UCOR_Data and confirm with "Ok".
c) Choose the file and confirm with "Select".
d) Select "Edit UCOR Data".
e) To fill the user correction data table, proceed as described in Chapter 8.9.3,
"User Correction", on page 570.
4. Select block diagram > RF A > "On".
5. Select "State > On".
The "UCOR" dialog contains all settings for creating and handling files with user-
defined level correction values.
The remote commands required to define these settings are described in Chap-
ter 14.19.5, "SOURce:CORRection Subsystem", on page 1114.
Settings
State............................................................................................................................573
User Correction...........................................................................................................574
UCOR Data ................................................................................................................574
Edit UCOR Data .........................................................................................................574
State
Activates user correction.
The R&S SMW displays the status icon "Lev Ucor" in the status bar.
Improving Level Performance