Monitoring Signal Characteristics
R&S
®
SMW200A
619User Manual 1175.6632.02 ─ 30
► Select "Fading A > On" to enable the fading simulator.
The power spectrum diagram shows the same shape, but the level changes
dynamically.
To observe the effect of enabled additive noise (AWGN)
1. Select "AWGN > General > Mode > Additive Noise".
2. Select "AWGN > General > Min Noise/System Bandwidth Ratio = 3".
3. Select "Noise Power / Output Results > Carrier/Noise Ratio = 30 dB".
Displaying Baseband Signal Characteristics in Real-Time
To Next Page
Loading...