Getting Started
R&S
®
SMW200A
62User Manual 1175.6632.02 ─ 30
RF
INPUT
REF OUT
(Rear Panel)
REF IN
RF A
Reference
Signal
INPUT
TRIGGER
Global Trigger 1
External Trigger Source
USER 3
Figure 3-14: Simplified representation of a test setup**
** = The figure depicts the cabling as a general principle; a particular test setup does not require all con-
nections at the same time.
The Figure 3-14 depicts the location of the connectors and explains the connection
as principle. In practice, you would rather "substitute" the analyzer by a DUT, like a
base station (BS). Other than in the example, the DUT can be the source for the
reference signal. Instead of an external trigger source, the DUT can send, e.g., a
frame trigger signal to the R&S SMW. The R&S SMW acts still as the signal
source.
Trying Out the Instrument
To Next Page
Loading...