Rohde & Schwarz R&S SMW200A - Baseband Powers Settings

Monitoring Signal Characteristics
R&S
®
SMW200A
627User Manual 1175.6632.02 ─ 30
9.2.3 Baseband Powers Settings
Access:
► Select "Taskbar > System Config > Setup > General > Baseband Powers".
The dialog provides a summarized information on the important baseband level
parameters, like power level and peak power (PEP) of selectable acquisition
points.
The remote commands required to define these settings are described in Chap-
ter 14.19.4.8, "SOURce:BB:MEASurement Subsystem", on page 1107.
Settings:
BB Powers Summary List........................................................................................... 627
Source/Output.............................................................................................................628
Acquisition...................................................................................................................628
Gate Source................................................................................................................628
Sweep Time/Duration..................................................................................................628
Level/PEP................................................................................................................... 629
Run Mode....................................................................................................................629
Add, Change, Remove, Start, Abort............................................................................629
Running/Stopped........................................................................................................ 630
BB Powers Summary List
Displays the measurement results of all currently enabled measurements.
You can configure and enable up to 8 measurements simultaneously. To enable a new
measurement or to change the settings of an existing one, use the Add, Change,
Remove, Start, Abort functions.
Querying Information on the Baseband Power Levels