Rohde & Schwarz R&S SMW200A - Page 655

Multi-Instrument Setups
R&S
®
SMW200A
655User Manual 1175.6632.02 ─ 30
"Error"
Settings conflict or missing connection to secondary instruments.
"Warning"
Indicates the following situations:
●
Selected frequency or PEP value outside of the calibrated range.
●
Temperature deviation (Temperature Offset to Last Calibration is
greater than +/- 3K)
●
Internal adjustment was performed since last calibration.
●
" LO Coupling = On" but the secondary instrument cannot be
synchronized.
A warning icon in the task bar indicates the erroneous situation.
Remote command:
:SCONfiguration:RFALignment:SETup:STATus? on page 938
Error History
Indicates the status of the alignment process.
10.4.2.2 RF Ports Setup Info
Access:
1. Select "System Configuration > Multi Instrument > RF Ports Alignment".
2. Select "Setup > User files > <... .rfsa > > Select".
3. Select "RF Ports Alignment" > "Info".
● Calibration Settings...............................................................................................656
● Current Corrections Settings.................................................................................659
● Setup Overview.....................................................................................................661
Generating Phase-Coherent Synchronous and Aligned Signals