Rohde & Schwarz R&S SMW200A - Page 656

Multi-Instrument Setups
R&S
®
SMW200A
656User Manual 1175.6632.02 ─ 30
Calibration Settings
Access:
► Select "RF Ports Alignment > Info" > "Calibration".
Figure 10-6: RF Ports Setup Info > Calibration
This dialog displays summary information on the calibration data as retrieved from
the setup file.
Settings:
Calibration Date/Time..................................................................................................656
Calibrated Parameters................................................................................................ 656
Time since Last Calibration......................................................................................... 657
Temperature Offset to Last Calibration....................................................................... 657
Frequency/PEP Control.............................................................................................. 657
└ Mode.............................................................................................................657
└ Frequency Range/PEP Range......................................................................657
└ Frequency Step/PEP Step............................................................................658
└ Frequency Values/PEP Values..................................................................... 658
└ LO Coupling..................................................................................................658
Calibration Date/Time
Indicates the date and time the calibration described in the loaded setup file is per-
formed.
Remote command:
:SCONfiguration:RFALignment:SETup:INFO:CALibration:DATE?
on page 939
:SCONfiguration:RFALignment:SETup:INFO:CALibration:TIME?
on page 939
Calibrated Parameters
Summary information on the major calibrated parameters.
Generating Phase-Coherent Synchronous and Aligned Signals