Multi-Instrument Setups
R&S
®
SMW200A
664User Manual 1175.6632.02 ─ 30
Figure 10-11: RF Ports Setup File Editor
The dialog displays an overview information on the following:
● Configured ports including user-defined port names
● The physical instruments on that the ports are located
● The filename of the files with calibration data
● If S-Parameter files are used during the calibration or loaded afterwards, the fil-
enames of these files.
The "RF Ports Setup File Editor" dialog is the central point to reconfigure and con-
trol your setup. Here, you can rename ports, add, remove or exchange S-parame-
ter files, retrieve information on connected external instruments, and save your set-
tings in a loadable setup file.
RF port table............................................................................................................... 664
└ Port Name.....................................................................................................664
└ RF Source.....................................................................................................664
└ Hostname / IP Address.................................................................................664
└ Remote Status.............................................................................................. 665
└ Additional S-Parameters Files...................................................................... 665
Save Setup .../Save Setup as .................................................................................... 665
RF port table
Represents the RF ports configuration; there is one table row per RF port.
Port Name ← RF port table
Add an alias name for the RF port.
RF Source ← RF port table
Indicates the physical instrument which the RF port belongs to.
Hostname / IP Address ← RF port table
Displays/sets the IP address or hostname of the connected external instrument.
Generating Phase-Coherent Synchronous and Aligned Signals
To Next Page
Loading...