Getting Started
R&S
®
SMW200A
67User Manual 1175.6632.02 ─ 30
The symbols and in the block diagram confirm that the signals are added
weighted with a frequency offset on both paths and a path gain on path B.
Figure 3-16: Block diagram: Generating a composed signal (stream A)
To enable simultaneous signal generation in both basebands, the R&S
SMW cou-
ples the trigger settings in the available basebands. The trigger settings enabled in
"Baseband A" apply automatically to the "Baseband B".
The symbol
confirms that common trigger settings are applied.
To map the I/Q stream and define the output connector
The term stream describes the signal at the input of the "I/Q Stream Mapper" up to the
output connectors of the instrument.
1. In the block diagram, select the "I/Q Stream Mapper" block.
The "System Configuration > I/Q Stream Mapper" dialog displays the current
(default) distribution and mapping of the I/Q streams to the output connectors as a
mapping matrix.
Trying Out the Instrument
To Next Page
Loading...